TM 9-2320-260-34-2
Install snapring (28) in notch on driveshafl (13).
29.
30.
Install breather (27) in side of housing (1).
31.
Aline hole (21) inside of ring support assembly (18) with hole (24) in side of housing (1), place ring
support assembly (18) on housing (1), and install with new lockwasher (19) and screw (20).
32.
Slide three wire leads (22), one at a time, through new grommet (23), and slide grommet (23) up
wire leads (22).
33.
Cut notch in upper lip of grommet (23), and install grommet (23) and three wire leads (22) through
hole (25) of flange plate (26). Aline notch to clear head of screw to be installed in flange plate (26)
at installation.
34.
Aline splines of coupling (17) with splines of driveshaft (13), and slide coupling (17) onto
driveshaft (13). Seat coupling (17) against snapring (28).
16-153
