TM 9-2320-260-34-2
16-23. HOIST HYDRAULIC WINCH MOTOR REPLACEMENT (M816)
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP
REFERENCES (TM)
APPLICABLE MODELS
LO 9-2320-260-12
M186
TM 9-2320-260-10
TOOLS
TM 9-2320-260-34P-2
General mechanic's tool kit
EQUIPMENT CONDITION
q Parking brake set (TM 9-2320-260-10).
MATERIALS/PARTS
q Hydraulic system drained (LO 9-2320-260-12).
CAUTION
Clean area around hoses and lines before removal to prevent
q
entry of dirt. Damage will occur if dirt or dust enters system.
q Cap or plug all openings after disconnecting hoses and lines to
hydraulic system.
NOTE
q Have drainage container ready to catch oil.
q Tag hoses for installation.
1. Remove hoses (3) from elbows (4). Secure hoses (3) away from hydraulic winch motor (9).
2. Attach chain to hydraulic winch motor (9) and lifting device. Take up slack in chain.
NOTE
Assistant will help with step 3.
3. Remove four screws (1), lockwashers (2), hydraulic winch motor (9), and gasket (6) from flange (5).
4. Remove woodruff key (7) from shaft (8). Discard woodruff key (7).
NOTE
Perform step 5 if hydraulic winch motor is being replaced with a
new unit.
5. Remove elbows (4) from hydraulic winch motor (9).
6. Remove chain from hydraulic winch motor (9) and lifting device.
1. Attach chain to hydraulic winch motor (9) and lifting device.
16-138