TM 9-2320-260-34-2
15-81. ENTRANCE RECEPTACLE REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-260-10
M820, M820A1, M820A2
TM 9-2320-260-20
TEST EQUIPMENT
TM 9-2320-260-34P-2
Multimeter (Appendix B, Item 115)
EQUIPMENT CONDITION
Tools
q External power source disconnected
(TM 9-2320-260-10).
General mechanic's tool kit
q Battery ground cable disconnected
(Appendix B, Item 1)
(TM 9-2320-260-20).
Toolkit, electrical (Appendix B, Item 106)
MATERIALS/PARTS
Four locknuts (Appendix D, Item 190)
Safety wire (Appendix D, Item 372)
Electrical tape (Appendix C, Item 51)
CAUTION
Use care when replacing wiring harness. Excessive snagging or
pulling may damage wiring harness.
NOTE
Tag wires, cables, and leads for installation.
1. Remove six screws (13) and cover (1) from load center (4).
2. Remove three screws (14) and wires (15) from 100-amp circuit breaker (17).
3. Remove setscrew (16) and wire (2) from neutral bar (3).
4. Remove three screws (9) from plate (10) and electrical box (11).
5. Remove four screws (6), locknuts (12), and receptacle (7) from van body (5). Discard locknuts (12).
NOTE
q Safety wire will be used to install new wiring harness. Do not
cut safety wire from spool until wiring harness has been pulled
through and proper length has been obtained.
q Safety wire must be attached to wires with electrical tape.
6. Remove entrance receptacle (8) from van body (5).
1. Position entrance receptacle (8) in van body (5).
2. Install receptacle (7) on van body (5) with four screws (6) and new locknuts (12).
3. Secure plate (10) on electrical box (11) with three screws (9).
4. Install wire (2) on neutral bar (3) with setscrew (16).
5. Install three wires (15) on 100-amp circuit breaker (17) with three screws (14).
6. Install cover (1) on load center (4) with six screws (13).
15-294
