TM 9-2320-260-34-2
15-13. DUMP BODY MAINTENANCE (Contd)
b. Cleaning, Inspection, and Repair
1.
For general cleaning instructions, refer to para. 2-8.
Inspect dump body (1) for dents, cracks, rust, and broken welds. Repair dump body (1) if dented,
2.
cracked, rusted, or welds are broken (TM 9-237).
3. Clean and paint dump body (1) as necessary (TM 43-0139).
c. Installation
1. Attach two chains and guide lines to dump body (1) and lifting device.
WARNING
All personnel must stand clear during lifting operations.
q
A shifting or swinging load may cause injury to personnel.
Ensure lifting capacity is greater than weight (2,700 lb
q
(1,226 kg)) of dump body. Failure to do so may result in injury
to personnel or damage to equipment.
NOTE
Assistant will help with steps 2 through 11.
Raise dump body (1) clear of supports and position on subframe (2).
2.
NOTE
Steps 3 through 5 apply to both left and right sides of vehicle.
3. Install hinge bracket (4) on dump body (1) with six screws (6) and new locknuts (5).
4. Insert hinge pin (9) in hinge bracket (4) and secure with screw (7) and new locknut (8).
5. Install lubrication fitting (3) in hinge pin (9).
6. Remove two guide lines from dump body (1).
7. Remove chains from dump body (1) and lifting device.
15-32
