TM 9-2320-260-34-1
Section III. AIR-HYDRAULIC SYSTEM MAINTENANCE
11-8. SERVICE BRAKE PEDAL LEVER AND BRACKET MAINTENANCE
THIS TASK COVERS:
c. Installation
a. Removal
b. Cleaning and Inspection
INITIAL SETUP
EQUIPMENT CONDITION
APPLICABLE MODELS
Wheels chocked (TM 9-2320-260-10).
All
Floorboard tunnel removed
TOOLS
(TM 9-2320-260-20).
General mechanic's tool kit
Brake pedal removed (TM 9-2320-260-20).
Clutch pedal removed (TM 9-2320-260-20).
(Appendix B, Item 1)
Arbor press (Appendix B, Item 7)
Clutch actuating lever link rod assembly removed
(TM 9-2320-260-20).
MATERIALS/PARTS
Master cylinder removed (TM 9-2320-260-20).
Five locknuts (Appendix D, Item 166)
Transfer-to-front axle propeller shaft removed
Four locknuts (Appendix D, Item 191)
(TM 9-2320-260-20).
Cap and plug set (Appendix C, Item 6)
Air reservoirs drained (TM 9-2320-260-10).
Antiseize tape (Appendix C, Item 50)
GENERAL SAFETY INSTRUCTIONS
REFERENCES (TM)
Drain air reservoir before disconnecting air lines.
TM 9-243
Eyeshields must be worn when removing
TM 9-2320-260-10
hydraulic lines.
TM 9-2320-260-20
TM 9-2320-260-34P-1
a. Removal
1. Remove screw (4) and locknut (3) from lever support (2) and main support bracket (5). Discard
locknut (3).
2. Remove screw (1), locknut (14), and lever support (2) from frame (11). Discard locknut (14).
3. Remove screw (12), locknut (8), and bracket (9) from frame (11). Discard locknut (8).
4. Remove lubrication fittings (22) from main support bracket (5).
WARNING
Eye protection is required when removing hydraulic lines.
Failure to do so may result in injury to personnel.
Drain air reservoirs before disconnecting air lines. Small parts
under pressure may shoot out with high velocity, causing injury
to personnel.
CAUTION
Cap or plug hydraulic lines after removal. Remove plugs prior to
installation. Failure to do so may result in damage to equipment.
5. Remove hydraulic line (10) from tee (15).
6. Remove four locknuts (6), screws (13), two locknuts (7), and screws (16) from main support
bracket (5) and frame (11). Discard locknuts (6) and (7).