TM
9-2320-260-34-1
10-8. DIFFERENTIAL AND DIFFERENTIAL CARRIER REPAIR (Contd)
Bend tab(s) (4) on locktab washer over flats on outer nut (1).
21.
Using arbor press, install rear bearing inner race (3) on short splined end of mainshaft (2).
22.
Using arbor press, install bearing (7) in rear bore (5) of differential earner housing (6).
23.
Install sleeve (8) in bore (13) with notches (10) toward shoulder of bore (13). Ensure hole (9) in
24.
sleeve (8) alines with hole (12) in differential carrier housing (6).
Install setscrew (11) through hole (12) until seated in sleeve (8).
25.
Press bearing (15) on hub (20) of bevel ring gear (21). Bearing (15) must rest against shoulder (14)
26.
on hub (20).
Install spacer washer (16) on keyed end (19) end of helical pinion gear (18).
27.
Install machine key (17) in keyed end (19) of helical pinion gear (18). Ensure exposed edges of
28.
machine key (17) are not burred after installation. Remove any burrs with fine mill file.
10-38