TM 9-2320-260-34-1
5-11. FLOW TEST (Contd)
NOTE
Do not place injector in stand. Hold injector in hand with thumb
over plunger.
1. Place test stand motor switch (2) in start position.
CAUTION
Temperature must not exceed 135F (57C). Drain and replace test
oil if temperature exceeds limit.
2. Temperature gage (3) should read 90-95F (32-35C).
3. Adjust regulator knob (4) until pressure gage (1) reads 150 psi (1034 kPa).
NOTE
Inspect burnishing tool installation hole for leaks. A slight seepage
is not harmful. Replace check ball if leakage is found.
4. Inspect burnishing tool installation hole (7) for leaks.
5. Place test stand motor switch (2) to OFF position.
6. Disconnect inlet pressure line adapter (6) from burnishing tool adapter (5).
5-30
