TM 9-2320-260-34-1
5-6. FUEL INJECTOR REPLACEMENT (Contd)
NOTE
Use injector puller, P/N 3376000, for non-top stop injectors. Use
injector puller, P/N 3375161, for top stop injectors.
2. Using injector puller, seat injector (6) in injector bore (5). A click will be heard when injector (6)
seats properly.
NOTE
Perform step 3 for installing top stop injectors found on late
model engines.
Perform step 4 for installing non-tap stop injectors found on
early model engines.
3. Install retaining clamp (3) on cylinder head (4) with two screws (2). DO not tighten screws (2).
4. Install washer (9) and retaining clamp (3) on cylinder head (4) with two screws (2). Do not tighten
screws (2).
5. Insert injector link (1) in injector plunger (8). Tighten two screws (2) 11-12 lb-ft (15-16 NZm) in
4 lb-ft (5 NZm) steps.
6. Raise injector link (1) and allow injector link (1) to fall back into injector plunger (8). If injector
link (1) bonds or sticks, loosen two screws (2) and retighten.
5-5