TM 9-2320-260-34-1
3-50. CYLINDER LINERS AND CYLINDER BLOCK MAINTENANCE (Contd)
d. Assembly
NOTE
Ensure all parts are clean and cylinder bore, counterbore, and
lower bore are lubricated with clean engine oil before assembly.
1.
Install new crevice seal (8) in crevice seal groove (10).
Install new black O-ring (7) in top O-ring groove (9).
2.
3. Install new red O-ring (6) in bottom O-ring groove (4).
e. Installation
1. Apply clean coat of engine oil to crevice seal (8) and O-rings (7) and (6).
NOTE
When installing cylinder liner be sure not to dislodge O-rings and
crevice seals.
2. Install shims (11), if necessary (steps 14-16, subtask c.), and cylinder liner (1) into cylinder block (5).
Using cylinder liner driver and cylinder liner clamp set, install cylinder liner (1) until liner
flange (3) is seated then clamp in place.
3-147
