TM 9-2320-260-34-1
3-10. INTAKE MANIFOLD MAINTENANCE
THIS TASK COVERS:
d. Assembly
a. Removal
e. Installation
b. Disassembly
c. Cleaning and Inspection
INITIAL SETUP
MATERIALS/PARTS (Contd)
APPLICABLE MODELS
Antiseize tape (Appendix C, Item 50)
All
Cap and plug set (Appendix C, Item 6)
TOOLS
REFERENCES (TM)
General mechanic's tool kit
TM 9-2320-260-20
(Appendix B, Item 1)
TM 9-2320-260-34P-1
Torque wrench, 3/8-in. dr.
(Appendix B, Item 4)
EQUIPMENT CONDITION
MATERIALS/PARTS
Preheater nozzle and glow plug removed
Fifteen lockwashers (Appendix D, Item 258)
(TM 9-2320-260-20).
Three gaskets (Appendix D, Item 105)
Air cleaner hose removed (TM 9-2320-260-20).
Gasket (Appendix D, Item 153)
CAUTION
Cap or plug all openings immediately after disconnecting lines and
hoses to prevent contamination. Failure to do so may result in
damage to equipment.
NOTE
Perform steps 1 and 2 for late model engines.
Engine intake manifold is mounted with screw-assembled
lockwashers on late model engine.
1.
Remove screw (28), lockwasher (27), washer (26), clamp (25), and tachometer driveshaft (24) from
air intake manifold (1). Discard lockwasher (27).
2.
Remove screw (31), lockwasher (30), washer (29), clamp (32), and air compressor outlet line (33)
from air intake manifold (1). Discard lockwasher (30).
Remove two screws (21), lockwashers (22), washers (23), clamps (19), and fuel supply lines (20) from
3.
air intake manifold (1). Discard lockwashers (22).
4.
Remove screw (21), lockwasher (22), washer (23), clamp (17), and harness (18) from air intake
manifold (1). Discard lockwasher (22).
5.
Remove two clamps (3) and hose (5) from elbow (6) and draft tube (4).
Remove elbow (6) from air intake connector (7).
6.
7.
Remove tube (12) and elbow (11) from air intake connector (7).
Remove two clamps (15) and hose (14) from air intake manifold (1) and air compressor inlet
8.
line (16).
9.
Remove six screws (10), lockwashers (9), washers (8), air intake manifold (1), and three gaskets (2)
from engine (13). Discard lockwashers (9) and gaskets (2).
