TM 9-2320-260-34-1
g. Oil Seals.
(1) Remove oil seals by pressing, pulling, or prying out. Be careful not to damage casting or adapter
bore.
(2) Always install new seal in bore using proper seal replacing tool.
h. Cylinder Head - Cylinder Block. Repair of cylinder head and cylinder block is limited to procedures
outlined in this manual.
i. Shafts.
(1) Parts showing evidence of overheating (especially discoloration) are not repairable; replace part.
(2) Minor corrosion at seal contact surface can be repaired. Pitting is unrepairable; replace part.
a. Cleanliness is essential in all component assembly operations. Dirt and dust, even in small quantities,
is abrasive. Parts must be cleaned as specified and kept clean. Wrap or cover parts and components when
assembly procedures are not immediately completed.
b. Coat all
bearings and
contact surfaces with
operating oil (axle oil for
axle parts, transmission oil for
transmission parts, etc.) after repair to ensure lubrication of parts during initial operation.
c. Use new gaskets and preformed packings during assembly of all components. Follow instructions on
package for prelubricated seals.
d. Torque values and
limits are
listed and
illustrated in
Appendix F.
e. Press fit operations require proper prelubrication of contact surfaces and care to maintain alinement
of mating parts and pressure tooling. Always follow press equipment operation instructions.
All painting shall be performed in accordance with the following publications:
Camouflage Materials (Field Manufacturing Techniques) . . . . . . . . . . . . . . . . . . . TM 5-200
Paint Instructions for Field Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TM 43-0139
Color, Marking, and Camouflage Painting of Military Vehicles,
Construction Equipment, and Materials Handling Equipment . . . . . . . . . . . . . . . TB 43-0209