TM 9-2320-260-20
Section II. DEEPWATER FORDING KIT MAINTENANCE
PAGE
PARA.
TITLE
NO.
NO.
Deepwater Fording Hand Control and Cable Replacement
Deepwater Fording Pressurization Valve Replacement
Deepwater Fording Pressure Relief Valve Replacement
Deepwater Fording Snorkel Replacement
I
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Locknut
Parking brake set (TM 9-2320-260-10).
Lockwasher
Hood raised and secured (TM 9-2320-260-10).
a. Removal
1. Loosen two screws (6) and remove control cable (7) from valve nuts (5).
2. Remove locknut (9), screw (4), clamp (3), and control cable (7) from bracket (8). Discard locknut (9).
3. Remove grommet (2) from hole in firewall (1).
4. Remove nut (11) and pull hand control (13) and control cable (7) from nut (11), lockwasher (12), and
instrument panel (10). Discard lockwasher (12).
1. Insert control cable (7) through hole in instrument panel (10), new lockwasher (12), and nut (11).
2. Install hand control (13) on instrument panel (10) with new lockwasher (12) and nut (11).
3. Insert control cable (7) through hole in firewall (1).
4. Place grommet (2) over control cable (7) and install on firewall (1).
5. Insert control cable (7) through two valve nuts (5) and tighten screws (6).
6. Install control cable (7) on bracket (8) with clamp (3), screw (4), and new locknut (9).
14-52
