TM 9-2320-260-20
I
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Twelve locknuts
Lockwasher
Parking brake set (TM 9-2320-260-10).
q
q Hood raised and secured (TM 9-2320-260-10).
q Fuel burning personnel heater removed
NOTE
Fuel burning personnel heater and hot water personnel heater
mounting brackets are removed basically the same. This procedure
covers the fuel burning personnel heater.
1. Remove four locknuts (3), washers (4), screws (9), washers (8), platform (24), and mounting plate (2)
from supports (6) and (23). Discard locknuts (3).
2. Remove four locknuts (1), washers (26), screws (25), and two brackets (5) from platform (2). Discard
locknuts (1).
3. Remove two locknuts (19), screws (22), and four washers (18) from supports (6) and (23) and
fender (20). Discard locknuts (19).
4. Remove locknut (7), washer (17), screw (21), and support (23) from frame (13). Discard locknut (7).
5. Remove locknut (10), lockwasher (11), ground cable (12), screw (16), washer (15), panel supPort (14),
and support (6) from frame (13). Discard locknut (10) and lockwasher (11).
1. Position support (6) and panel support (14) on frame (13) with washer (15) and screw (16).
2. Install ground cable (12) on screw (16) and frame (13) with new lockwasher (11) and new
locknut (10).
3. Install support (23) on frame (13) with screw (21), washer (17), and new locknut (7).
4. Install supports (6) and (23) on fender (20) with two screws (22), four washers (18), and two new
locknuts (19).
5. Install two brackets (5) on platform (2) with four screws (25), washers (26), and new locknuts (l).
6. Install mounting plate (2) and platform (24) on supports (6) and (23) with four screws (9),
washers (8), washers (4), and new locknuts (3).
14-4
