TM 9-2320-260-20
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
M817
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Cotter pin
Parking brake set (TM 9-2320-260-10).
Woodruff key
Driver's seat removed (para. 11-32).
Six locknuts
1. Remove cotter pin (11), clevis pin (9), and control rod (10) from lever (15). Discard cotter pin (11),
2. Bend four tabs (20) and remove boot (12) from floor (8).
NOTE
Assistant will help with step 3.
3. Remove four locknuts (13), screws (14), and two brackets (7) from floor (8). Discard locknuts (13).
4. Remove locknut (17), screw (16), lever (15), and woodruff key (18) from shaft (l). Discard
locknut (17) and woodruff key (18).
5. Remove two brackets (7) from shaft (1).
6. Remove locknut (6), washer (5), spring (4), and lock (2) from lever (3). Discard locknut (6).
7. Remove two grease fittings (19) from brackets (7).
1.
Install two grease fittings (19) on brackets (7).
2.
Install lock (2) on lever (3) with spring (4), washer (5), and new locknut (6).
3.
Position two brackets (7) on shaft (1).
4.
Install new woodruff key (18) on shaft (1).
5.
Install lever (15) on shaft (1) with screw ( 16) and new locknut (17).
NOTE
Assistant will help with step 6.
6.
Install two brackets (7) on floor (8) with four screws (14) and new locknuts (13).
7.
Install boot (12) through opening in floor (8) and bend tabs (20) to secure in place.
8.
Install control rod (10) on lever (15) with clevis pin (9) and new cotter pin (11).
13-68
