TM 9-2320-260-20
I
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-260-10
M816
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Four lockwashers
Parking brake set (TM 9-2320-260-10).
NOTE
All rear winch cable rollers are replaced basically the same. There
are two rollers alined vertically, and two alined horizontally. This
procedure is for vertically alined rollers.
1. Remove two screws (8), lockwashers (7), and plate (6) from bracket (5). Discard lockwashers (7).
2. Remove shaft (10) from roller (14).
3. Remove two lubrication fittings (9) from shaft (10).
4. Remove two screws (4), lockwashers (3), and plate (2) from bracket (5). Discard lockwashers (3).
5. Remove roller (14) from bracket (5).
6. Remove retainer (1), spacer (17), washer (16), bearings (15) and (13), washer (12), and spacer (11)
from roller (14).
1. Install bearings (13) and (15), washer (12), spacer (11), washer (16), spacer (17), and retainer (1)
on roller (14).
2. Position roller (14) on bracket (5).
3. Install plate (2) on bracket (5) with two new lockwashers (3) and screws (4).
4. Install two lubrication fittings (9) on shaft (10).
5. Position shaft (10) through roller (14) and install on bracket (5) with plate (6), two new
lockwashers (7), and screws (8).
13-50
