TM 9-2320-260-20
I
THIS TASK COVERS:
a. Removal
d. Assembly
b. Disassembly
e. Installation
c. Cleaning and Inspection
INITIAL SETUP
EQUIPMENT CONDITION
APPLICABLE MODELS
Parking brake set (TM 9-2320-260-10).
M815
Midwinch removed (para. 13-12).
MATERIALS/PARTS
Ramps removed (TM 9-2320-260-10).
Sixty-four locknuts
GENERAL SAFETY INSTRUCTIONS
PERSONNEL REQUIRED
All personnel must stand clear during lifting
Two
operations.
REFERENCES (TM)
TM 9-2320-260-10
TM 9-2320-260-20P
a. Removal
1. Install chain on cab protector (3).
2. Install lifting device on chain. Remove slack from chain.
3. Remove sixteen locknuts (9) and screws (7) from cab protector (3) and frame (8). Discard
locknuts (9).
WARNING
All personnel must stand clear during lifting operations. A swing-
ing or shifting load may cause injury or death to personnel.
4. Raise cab protector (3) from frame (8) and lower onto supports.
5. Remove lifting device from chain.
6. Remove chain from cab protector (3).
b. Disassembly
1. Remove twenty-four locknuts (6), screws (4), and six wood boards (5) from cab protector (3). Discard
locknuts (6).
2. Remove twenty-four locknuts (10), screws (1), and three wood boards (2) from cab protector (3).
Discard locknuts (10).
c. Cleaning and Inspection
1. Clean cab protector (3).
2. Inspect cab protector (3) for cracks, breaks, and rust. Replace cab protector (3) if cracked, broken,
or rusted.
3. Inspect nine wood boards (2) and (5) for split ends or severe rot. Replace boards (2) or (5) if damaged.
12-126
