TM 9-2320-260-20
9-5. REAR HUB AND DRUM MAINTENANCE (Contd)
6. Install inspection cover (7), ten new lockwashers (6), and nuts (5) on drum (8). Tighten nuts (5)
48-61 lb-ft (65-83 Nm).
7. Install new wiper (18), inner bearing (16), and new inner grease seal (17) on spindle (19).
CAUTION
Do not slide hub and drum assembly over threaded end of spindles.
Damage to spindles may result.
NOTE
Assistant will help with step 8.
8. Install hub (2), drum (8), and spacer (4) (if equipped) on spindle (19).
9. Install new cork gasket (26) in spindle keyway (25).
10. Install outer bearing (24) on spindle (19).
11. Install outer grease seal (23) in hub (2).
12. Install inner adjusting nut (22) on spindle (19) and check brake adjustment (para. 8-9).
13. Install rear wheels on axles (para. 9-3), but do not lower vehicle.
14. Install adjusting nut washer (21) and outer adjusting nut (20) on spindle (19).
15. Adjust bearings (16) and (24) (para. 9-6).
Install wheels (para. 9-3).
Lower rear axles (para. 9-2).
9-19
