TM 9-2320-260-20
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP
EQUIPMENT CONDITION
APPLICABLE MODELS
Parking brake set (TM 9-2320-260-10).
M815, M818, M819
Air reservoirs drained (TM 9-2320-260-10).
MATERIALS/PARTS
GENERAL SAFETY INSTRUCTIONS
Two lockwashers
Do not disconnect air lines before draining air
Antiseize tape (Appendix C, Item 30)
reservoirs.
REFERENCES (TM)
TM 9-2320-260-10
TM 9-2320-260-20P
WARNING
Do not disconnect air lines before draining air reservoir. Small
parts under pressure may shoot out with high velocity, causing
injury to personnel.
NOTE
Tag air tubes for installation.
1. Disconnect two air tubes (7) from adapters (8).
2. Remove two screws (3), lockwashers (4), clamp (5), control valve (1), and strap (6) from steering
column (2). Discard lockwashers (4).
3. Remove two adapters (8) from control valve (1).
I
b. Installation
I
1. Apply anti seize tape to male threads of two adapters (8).
2. Install two adapters (8) on control valve (1).
3. Install strap (6), control valve (1), and clamp (5) on steering column (2) with two new
lockwashers (4) and screws (3). Finger tighten screws (3).
4. Connect air tubes (7) to adapters (8).
5. Tighten two screws (3).
8-48
