TM 9-2320-260-20
I
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Two seal washers
Locknut
Parking brake set (TM 9-2320-260-10).
Cap and plug set (Appendix C, Item 9)
Antiseize tape (Appendix C, Item 30)
When removing hydraulic flexible hose from wheel cylinder plug,
open line and port. Failure to do so may damage hydraulic system.
1. Remove locknut (12), screw (6), and spring (7) from clamp (8) and bracket (5). Discard locknut (12).
NOTE
Have drainage container ready to catch brake fluid.
2. Remove brake line screw (4), two seal washers (2), and fitting (3) from wheel cylinder (13). Discard
seal washers (2).
3. Remove fitting (3) from hose (1).
NOTE
Visually inspect brackets. Replace if damaged.
4. Remove brake line (9), nut (10), and hose (1) from bracket (11).
I
b. Installation
1. Apply antiseize tape to male threads of hose (1) and brake line (9).
2. Insert hose (1) through bracket (11) and install nut (10) and brake line (9) on bracket (11).
3. Install fitting (3) on hose (1).
4. Install two new seal washers (2), fitting (3), and brake line screw (4) on wheel cylinder ( 13),
5. Install clamp (8) and spring (7) on hose (1) with screw (6) and new locknut (12).
6. Install spring (7) on bracket (5).
8-24
