TM 9-2320-260-20
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP
REFERENCES (TM)
APPLICABLE MODELS
All
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Seven locknuts
Front wheels chocked (TM 9-2320-260-10).
Parking brake released (TM 9-2320-260-10).
q Parking brake lever removed (para. 8-1).
I
a. Removal
1. Remove four locknuts (15), screws (13), two clamps (17), eight washers (16), and wear plate (14)
from brake cable (3). Discard locknuts (15).
2. Remove locknut (19), screw (2), clamp (1), and brake cable (3) from bracket (20). Discard
locknut (19).
NOTE
Measure parking brake cable nut position on threaded end of
brake cable for installation.
3. Remove jamnut (9), adjusting nut (10), and threaded end (7) of brake cable (3) from lever (8).
4. Remove two locknuts (12), screws (5), clamp (6), brake cable (3), and spacer (4) from transfer case
bracket (11). Discard locknuts (12).
b. Installation
Insert threaded end (7) of brake cable (3) through eye of lever (8) and install adjusting nut (10)
1.
to previously measured distance on threaded end (7) of brake cable (3).
2.
Install jamnut (9) on threaded end (7) of brake cable (3) and tighten jamnut (9) against adjusting
nut (10).
3.
Install spacer (4), brake cable (3), and clamp (6) on transfer case bracket (11) with two screws (5)
and new locknuts (12).
Install wear plate (14) on brake cable (3) approximately 12 in. (30.5 mm) from end of brake cable (3)
4.
with eight washers (16), two clamps (17), four screws (13), and new locknuts (15). Do not tighten
locknuts (15).
Adjust position of wear plate (14) to protect brake cable (3) from rubbing edge of toolbox (18).
5.
Tighten locknuts (15).
Install brake cable (3) on bracket (20) with clamp (1), screw (2), and new locknut (19).
6.
8-4
