TM 9-2320-260-20
I
THIS TASK COVERS:
c. Installation
a. Removal
b. Cleaning and Inspection
lNITIAL SETUP
APPLICABLE MODELS
EQUIPMENT CONDITION
All
Parking brake set (TM 9-2320-260-10).
q Vehicle-raised and supported by rear frame
MATERIALS/PARTS
(para. 9-21.
Six lockwashers
q Rear spring removed (para. 7-17).
Key washer
GENERAL SAFETY INSTRUCTIONS
Gasket
Seal
q Ensure vehicle is firmly supported.
Drycleaning solvent (Appendix C, Item 29)
q Keep fire extinguisher nearby when using
-
Wiper
dry cleaning solvent.
Rags (Appendix C, Item 22)
REFERENCES (TM)
LO 9-2320-260-12
TM 9-214
TM 9-2320-260-10
TM 9-2320-260-20P
NOTE
Rear spring seat maintenance may be performed with the cross
tube removed from vehicle (para. 7-20). This procedure is
performed with cross tube installed on vehicle.
I
a. Removal
WARNING
Ensure vehicle is firmly supported during removal of spring seat.
Failure to do so may result in injury to personnel.
1. Remove six screws (18), lockwashers (17), cap (16), and gasket (15) from spring seat (14). Discard
lockwashers (17) and gasket (15).
2. Remove nut (9), key washer (10), adjusting nut (11), outer bearing (12), and spring seat (14) from
cross tube (4). Discard key washer (10).
3. Remove inner bearing (2), retainer (3), seal (8), wiper (7), support (6), and washer (5) from cross
tube (4). Discard seal (8) and wiper (7).
4. Remove races (1) and (13) from spring seat (14).
7-40
