TM 9-2320-260-20
Section IV. FUEL SYSTEM MAINTENANCE
3-19. GENERAL
a. For fabrication instructions of fuel lines, refer to TM 9-243. When replacing air lines, note the
location and position of mounting hardware. Replace any missing or broken mounting hardware
(TM 9-2320-260-20P).
b. For schematic representation of fuel line locations and routing, see appendix E of this manual.
PARA.
PAGE
TITLE
NO.
NO.
Selector Valve Flex Hose Replacement
Selector Valve and Mounting Bracket Maintenance
Fuel Supply and Return Tubes Replacement
Fuel Tank Maintenance
Fuel Tank Straps and Hangers Maintenance
Fuel Filter/Water Separator Maintenance
Fuel Pump Filter Replacement (VS, MVS)
Fuel Pump Filter Replacement (AFC)
Primer Pressure Gage Replacement
Preheater Nozzle and Glow Plug Replacement
Preheater Primer Pump Replacement
Cold Start Indicator and Lamp Replacement
Cold Start Resistor Replacement
Cold Start Replay Replacement
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
EQUIPMENT CONDITION
M816, M817, M818
q Parking brake set (TM 9-2320-260-10).
q Toolbox removed (para. 11-29).
MATERIALS/PARTS
GENERAL SAFETY INSTRUCTIONS
Cap and plug set (Appendix C, Item 9)
Antiseize tape (Appendix C, Item 30)
Diesel fuel is flammable. Do. not perform this task
near fire, flame, or sparks.
REFERENCES (TM)
TM 9-2320-260-10
TM 9-2320-260-20P
