TM 9-2320-260-20
CHAPTER 2
SERVICE AND TROUBLESHOOTING INSTRUCTIONS
Repair Parts, Special Tools, TMDE, and Support Equipment (page 2-1)
Section
I.
Section
II.
Service Upon Receipt (page 2-1)
Preventive Maintenance Checks and Services (PMCS) (page 2-2)
Section
III.
Section
IV.
Mechanical Systems Troubleshooting (page 2-66)
Compressed Air and Air-Hydraulic Brake System Troubleshooting (page 2-88)
Section
V.
Electrical Systems Troubleshooting (page 2-96)
Section
VI.
Section
VII.
STE/ICE Troubleshooting (page 2-186)
Section I. REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment
(MTOE) applicable to your unit.
Special Tools, Special Test, Measurement, and Diagnostic Equipment (TMDE), and Support Equipment
used to maintain the vehicles covered in this manual can be found in TM 9-2320-260-20P.
Repair parts covering unit maintenance are listed and illustrated in the Repair Parts and Special Tools
List (TM 9-2320-260-20P).
Section II. SERVICE UPON RECEIPT
a. Upon receipt of a new, used, or reconditioned vehicle, you must determine if the vehicle has been
properly prepared for service. The following steps should be performed:
(1) Inspect all assemblies, subassemblies, and accessories to be sure they are in proper working order.
(2) Secure, clean, lubricate, or adjust as needed.
(3) Check all Basic Issue Items (TM 9-2320-260-10) to be sure every item is present, in good condition,
and properly mounted or stowed.
(4) Follow general procedures for all service and inspections given in TM 9-2320-260-10.
b. The operator will assist when performing service upon receipt inspections.
c. Refer to TM 9-2320-260-10 when testing equipment for proper operation.
The following steps should be taken while performing general inspections and services:
(1) Use TM 9-2320-260-10 and LO 9-2320-260-12, as well as other sections of this manual, when
servicing and inspecting equipment.
2-1
