TM 9-2320-211-34P
SECTION I
INTRODUCTION
Code
1-1. Scope
Explanation
Assigned to items which are NSA design con-
P10
This manual lists repair parts and special tools
trolled: special tools, test, measuring and
required for the performance of direct support,
diagnostic equipment for COMSEC support.
general support, and depot maintenance of the 5-
which are accoountable under the previsions of AR
Ton, 6 x 6 Truck.
280-41, and which are stocked and supplied by
the Army COMSEC Logistic System,
1-2. General
Repair Parts. Special Tools and Test Equipment
M
This Repair Parts and Special Tools List is divided
which are not procured or stocked, as such, in the
into the following sections:
supply system but are to be manufactured at
a. Repair Parts-Section II. A list of repair
parts authorized for the performance of main-
Assemblies which are not procured or stocked as
A
tenance at the direct support, general support and
such, but are made up of two or more units. Such
component units carry individual stock numbers
depot maintenance level in figure and item number
and descriptions, are procured and stocked
sequence.
separately and can be assembled to form the
b. Special Tools, Test and Support Equip-
required assembly at indicated maintenance
ment -- Section III. A list of special tools, Test, and
categories.
Support equipment authorized for the performance
Parts and assemblies that are not procured or
X
of maintenance at the direct support, general
stocked because the failure rate is normally below
that of the applicable end item of component. The
support and depot level.
failure of such part or assembly should result in
c. Federal Stock Number and Reference In-
retirement of the end item from the supply system.
dex -- Section IV. A list of Federal stock numbers
Repair Parts which are not procured or stocked.
X1
in ascending numerical sequence followed by a list
The requirement for such items will be filled by
of reference numbers in ascending alpha-numeric
the next higher assembly or component.
sequence, cross-referenced to the illustration figure
X2
Repair Parts, Special Tents, and Test Equipment
number and item number.
which are not stocked and have no foreseen
mortality. The indicated maintenance category
1-3. Explanation of Columns
requiring such repair parts will attempt to obtain
The following provides an explanation of columns
the parts through cannibalization or salvage, if not
{obtainable through cannibalization (or salvage, the
in the tabular list in section II and 111,
item may he requisitioned with exception data,
a. Source, Maintenance, and Recoverability
from the end item manager. for immediate use.
Codes (SMR), Column 1.
G
Major assemblies that are procured with PEMA
(1) Source code, indicates the section status
funds for initial issue only as exchange assemblies
and source for the listed item. Source codes used
at DSU and GSU level. These assemblies will not
are--
be stocked above the DS and GS level or returned
to depot supply level.
Explanation
Code
P
Repair Parts. Special Tools and Test Equipment
NOTE
supplied from GSA/DSA, or Army supply
Cannibalization or salvage may be used as
system, and authorized for use at indicated
a source of supply for any items source
maintenance categories.
P2
coded above, except those coded X1.
Repair Parts, Special Tools and Test Equipment
(2) Maintenance Code, indicates the lowest
purposes because the combat or military essen-
category of maintenance authorized to install the
tiality of the end item dictates that a minimum
listed item. The maintenance level codes are--
quantity be available in the supply system.
Code
P9
Explanation
Assigned to items which are NSA design con-
Crew of Operator Maintenance
trolled: unique repair parts, special tools, test,
C
measuring and diagnostic equipment, which are
Organization Maintenance
O
stocked and supplied by the Army COMSEC
Direct Support Maintenance
F
Logistic System and which are not subject to the
General Support Maintenance
H
provisions of AR 380-41.
Depot Maintenance
D
1-1