TM 11-7440-293-14
4-55. POWER SUPPLY.
Instructions for installing power supply are given in this section.
Preparing power cable for connection to Hubbell connector plug
Preparing power cable for connection to power supply
Connecting power cable to power supply
Installing power supply
Connecting power supply cable from de/de switch to power supply
Installing guard assembly
4-56. PREPARING POWER CABLE FOR CONNECTION TO HUBBELL CONNECTOR PLUG.
This task covers:
1. Preparation
2. Installation
INITIAL SETUP
Personnel Required
Tools
One mechanic
Wire cutters
Wire strippers
Flat-tip screwdriver
Equipment Condition
Plug receptacle installed.
Materials/Parts
Power cable (5 feet long)
Hubbell connector plug
ACTION
REMARKS
ITEM
LOCATION
PREPARATION
NOTE
Cut 5-foot power cable to 4 feet in length and save re-
mainder for different voltage hookups in power supply.
Using wire strippers, strip 2 inches of outer
1. Power cable
Outer
insulation.
insulation (1)
Using wire strippers, strip 5/8 inch of
2.
Black wire (2),
insulation from each wire.
white wire (3) and
green wire (4)
Power cable (5)
Using flat-tip screwdriver, install.
3. Hubbell connector
plug
and screws (6)
4-104
