TM 9-2320-272-24-3
4-68. REAR WIRING HARNESS REPLACEMENT (Contd)
NOTE
Perform step 24 for M931/A1/A2 and M932/A1/A2 vehicles only.
24.
Remove locknut (4), screw (2), clamp (3), two ground wires (6), and lockwasher (5) from rear
crossmember frame rail (1). Discard locknut (4) and lockwasher (5).
NOTE
Perform step 25 for all vehicles except M931/A1/A2 and
M932/A1/A2 vehicles.
25.
Remove locknut (11), screw (7), two ground wires (10), and lockwasher (9) from rear frame
rail (8). Discard locknut (11) and lockwasher (9).
NOTE
Receptacle cover must be lifted and held open to remove top two
screws.
26.
Remove four locknuts (15), screws (17), receptacle cover (12), and trailer cable receptacle (13) from
rear crossmember frame (8). Discard locknuts (15).
27.
Pull rear portions of rear wiring harness (16) through hole (14) in rear crossmember frame (8).
b. Installation
CAUTION
Use care when routing harness. Snagging may occur, and forceful
pulling will result in damage to harness.
1.
Route rear wiring harness (16) through hole (14) in rear crossmember frame (8) and lay out in
approximate position.
NOTE
Receptacle cover must be lifted and held open to install top two
screws.
2.
Install trailer cable receptacle (13) and receptacle cover (12) with four screws (17) and new
locknuts (15).
4-454