TM 9-2320-272-24-1
3-139. TRANSMISSION OIL COOLER FILTER AND HEAD REPLACEMENT
THIS TASK COVERS:
c. Oil Cooler Filter Head Installation
a. Oil Cooler Filter Removal
d. Oil Cooler Filter Installation
b. Oil Cooler Filter Head Removal
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
LO 9-2320-272-12
All
TM 9-2320-272-10
TOOLS
TM 9-2320-272-24P
General mechanic's tool kit (Appendix E, Item 1)
EQUIPMENT CONDITION
MATERIALS/PARTS
l Parking brake set (TM 9-2320-272-10).
l Hood raised and secured (TM 9-2320-272-10).
Oil filter (Appendix D, Item 491)
Three locknuts (Appendix D, Item 299)
Lubricating oil (Appendix C, Item 48)
Rag (Appendix C, Item 58)
Cap and plug set (Appendix C, Item 14)
a. Oil Cooler Filter Removal
NOTE
Have drainage container ready to catch oil.
Remove oil filter (3) and oil filter seal (2) from oil filter head (1). Drain oil and discard oil filter (3) and
oil filter seal (2).
b. Oil Cooler Filter Head Removal
CAUTION
Clean area around hoses before removal to prevent entry of dirt.
l
Damage may occur if dirt or dust enters the transmission.
Cover or plug all open hoses and connections immediately after
l
disconnection to prevent contamination. Failure to do this may
result in transmission damage.
NOTE
Have drainage container ready to catch oil.
l
l Tag hoses for installation.
1.
Remove
oil filter (3) as shown in task a.
2.
Remove
oil filter supply hose (8) from adapter elbow (7).
3.
Remove
supply hose (9) from adapter elbow (10).
4.
Remove
three locknuts (4), screws (6), and oil filter head (1) from oil filter bracket (5). Discard
locknuts
(4).
3-376
