• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
BRAKE SYSTEM (M816, M819, M821)
Test 3. Test voltage input into microbrake lock

TM-9-2320-260-20 5-Ton 6x6 M809 Series Trucks (Diesel) Truck Cargo: 5-Ton 6x6 M813 (2320-00-050-8902) (EIC:BSB); Manual
Page Navigation
  248    249    250    251    252  253  254    255    256    257    258  
TM 9-2320-260-20
Table 2-4. Electrical Troubleshooting (Contd).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Test 2. Test voltage into microbrake switch.
Step 1. Disconnect lead 10 from microbrake switch.
Step 2. Turn battery switch to ON position.
Step 3. Turn ignition switch to RUN position.
Step 4. Set multimeter to a range that will measure 24 volts.
Step 5. Touch positive lead of multimeter to contact end of lead 10.
Step 6. Touch negative lead of multimeter to frame ground. Voltage should be present.
a. If voltage is present, go to step 7.
b. Repair or replace lead 10 if voltage is not present (para. 4-52 or 4-54).
Step 7. Install lead 10 in microbrake switch.
Step 8. Disconnect lead 480 at microbrake switch.
Step 9. Touch positive lead of multimeter to contact end of microbrake switch.
Step 10. Touch negative lead of multimeter to frame ground.
Step 11. Press microbrake switch. Voltage should be present.
a. If voltage is present, go to test 3.
b. Replace microbrake switch if voltage is not present (para. 4-21).
2-179






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.