TM 9-2320-272-24-4
5-36. FUEL INJECTION PUMP MAINTENANCE (Contd)
NOTE
Steps 10 through 12 cover removal of one tappet holder. Remaining
tappet holders are removed the same.
10.
Turn knurled handle (7) on tappet holder (8) fully clockwise.
NOTE
Cylinder number one is located at drive end of fuel injection pump.
11.
Hold tappet holder (8) and rotate camshaft (9) until cylinder number one is at TDC and pull tappet
holder (8) from side hole (6).
12.
Rotate camshaft (9) until cylinder number two is at TDC and remove tappet holder (8) from side
hole (6).
13.
Install new seal ring (4) and bottom cover (3) on fuel pump housing (5) with six holding
brackets (1) and screws (2).
5-260