TM 9-2320-272-24-4
5-17. GOVERNOR WEIGHT MAINTENANCE
THIS TASK COVERS:
c. Installation
a. Removal
b. Inspection
INITIAL SETUP:
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-272-24P
M939/A1
EQUIPMENT CONDITION
TOOLS
Throttle cover and shaft disassembled (para. 5-16).
General mechanic's tool kit (Appendix E, Item 1)
a. Removal
1.
Remove governor weight (6) and gear (2) from front drive cover (1).
2.
Remove weight-assist plunger (5), spring (3), and shims (4) from governor weight (6).
b. Inspection
1.
Inspect spring (3) for bent or broken coils. If bent or broken, replace spring (3).
2.
Inspect governor weight gear (2) for cracked, broken, or pitted teeth. If cracked, broken, or pitted,
replace governor weight (6).
c. Installation
1.
Install shims (4), spring (3), and weight-assist plunger (5) in governor weight (6).
NOTE
Large end of weight-assist plunger is installed first.
2.
Install governor weight gear (2) and governor weight (6) on front drive cover (1).
5-102
