TM 9-2320-272-24-3
4-212. TRANSMISSION POWER TAKEOFF (PTO) MAINTENANCE (Contd)
6.
Remove input gear (6), drive gear (5), and two thrust washers (2) from PTO housing (1). Discard
thrust washers (2).
7.
Slide input gear (6) off drive gear (5).
8.
Remove nineteen needle bearings (3) from each end of drive gear (5).
9.
Remove spacer (4) from drive gear (5).
NOTE
Before removing input bearing cap from PTO housing, mark cap
l
and housing for installation.
Exact number of gaskets found when removing bearing caps
l
may vary.
10.
Remove four screws (22), output bearing cap (21), and gasket (20) from PTO housing (1). Discard
gasket (20).
11.
Remove four screws (17), input bearing cap (18), and gasket (19) from PTO housing (1). Discard
gasket (19).
NOTE
Mark lever, shaft, shifter cover, and hole containing poppet and
spring for installation.
12.
Remove screw (7), lockwasher (8), lever (9), washer (10), gear controller (14), poppet (13), and
spring (12) from shifter cover (11). Discard lockwasher (8).
13.
Remove O-ring (16) from gear controller shaft (15). Discard O-ring (16).
4-990
