TM 9-2320-272-24-3
4-142. CARGO BODY ASSEMBLY MAINTENANCE (Contd)
6.
Lower cargo body (12) onto frame (19) while using a drift pin to align two front upper holddown
brackets (2) to lower holddown brackets (3), and four intermediate holddown brackets (9) to lower
holddown brackets (10).
7.
Place four outer support springs (7) over inner support springs (4), and position under lower
holddown brackets (3), and install with four screws (1), washers (6), and locknuts (5). Tighten
locknuts (5) until length of springs (7) and (4) are 6.75 in. 0.06 in. (171.45 mm 1.5 mm).
NOTE
Extra-long wheelbase models (M927/A1/A2, M928/A1/A2) utilize
six intermediate holddown brackets, twelve screws, and twelve
locknuts.
8.
Place four screws (8) through intermediate holddown brackets (9) and lower holddown brackets (10),
and install four new locknuts (11).
9.
Disconnect lifting device, utility chains, and guide lines from cargo body (12).
10.
Connect four wires (16) to connectors (17) on each of two composite lights (18).
11.
Install eight wire clamps (14) on cargo body (12) with eight screws (15) and locknuts (13).
4-720
