TM 9-2320-272-24-2
3-402. ENGINE COOLANT OIL PAN SHROUD AND EXHAUST TUBE REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-272-10
TM 9-2320-272-24P
TOOLS
General mechanic's tool kit (Appendix E, Item 1)
EQUIPMEMT CONDITION
Parking brake set (TM 9-2320-272-10).
MATERIALS/PARTS
Two locknuts (Appendix D, Item 291)
1.
Remove two locknuts (4), screws (10), and clamps (9) from exhaust tube (13), crossmember (11), and
bracket (12). Discard locknuts (4).
2.
Open toolbox door (1).
3.
Remove two cotter pins (31, exhaust tube (13). and elbow (14) from engine coolant heater (2) and oil
4.
Remove cotter pin (3) and elbow (14) from exhaust tube (13). Discard cotter pin (3).
5.
Remove four nuts (8), washers (7), and oil pan shroud (6) from oil pan studs (5).
b. Installation
Install oil pan shroud (6) on oil pan studs (5) with four washers (7) and nuts (8).
1.
2.
Install elbow (14) on exhaust tube (13) with new cotter pin (3).
3.
Install exhaust tube (13) and elbow (14) on engine coolant heater (2) and oil pan shroud (6) with two
new cotter pins (3).
4.
Close toolbox door (1).
5.
Install exhaust tube (13) on crossmember (11) and bracket (12) with two clamps (9), screws (10), and
new locknuts (4).
3-984