TM 9-2320-272-24-1
3-191. WASHER CONTROL VALVE REPLACEMENT
THIS TASK COVERS
b. Installation
a. Removal
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-272-10
TM 9-2320-272-24P
TOOLS
EQUIPMENT CONDITION
General mechanic"s tool kit (Appendix E, Item 1)
Air reservoirs drained (TM 9-2320-272-10),
MATERIALS/PARTS
GENERAL SAFETY INSTRUCTIONS
Antiseize tape (Appendix C, Item 72)
Do not dirconnect air liner before draining air
reservoirs.
Do not disconnect air lines before draining air reservoirs. Small
parts under pressure may shoot out with high velocity, causing
injury to personnel.
1.
Remove
setscrew (6) and knob (7) from shaft (10).
2.
Remove
retaining ring (8), nut (5), washer (4), and washer control valve (3) from instrument panel (9).
3.
Remove
clamp (11) and washer bottle delivery line (12) from washer control valve (3).
4.
Remove
manifold tee supply line (1) from elbow (2).
If new valve is being installed, use fittings from old valve.
Wrap all male pipe threads with antiseize tape before
installation.
1.
Install
manifold tee supply line (1) on elbow (2).
Install
delivery line (12) on washer control valve (3) with clamp (11).
2.
3.
Install
washer control valve (3) on instrument panel (9) with washer (4) and nut (5).
4.
Install
retaining ring (8) and knob (7) on shaft (10) with setscrew (6).
3-524
