TM 9-2320-272-24-1
3-166. SHOCK ABSORBER AND MOUNTING PINS REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-272-10
TM 9-2320-272-24P
TOOLS
General mechanic's tool kit (Appendix E, Item 1)
EQUIPMENT CONDITION
Parking brake set (TM 9-2320-272-10).
MATERIALS/PARTS
Two locknuts (Appendix D, Item 286)
Two locknuts (Appendix D, Item 294)
Four rubber bushings (Appendix D, Item 564)
1.
Remove two locknuts (1) and washers (2) from mounting pins (4). Discard locknuts (1).
2.
Remove two rubber bushings (3), shock absorber (5), and two rubber bushings (3) from mounting
studs (4). Discard rubber bushings (3).
3.
Remove two locknuts (8) and screws (6) from mounting brackets (7). Discard locknuts (8).
4.
Spread two mounting brackets (7) and remove mounting pins (4).
NOTE
Ensure pin slots are positioned to allow installation of screw.
1.
Install two mounting pins (4) on mounting brackets (7) with two screws (6) and new
locknuts (8).
2.
Position four rubber bushings (3) and shock absorber (3) on two mounting pins (4).
3.
Install four rubber bushings (3) and shock absorber (5) on two mounting pins (4) with washers (2)
and new locknuts (1). Tighten locknuts (1) until seated and rubber bushings (3) are compressed.
3-452
