TM 9-2320-272-24-1
3-148. TRANSMISSION TO TRANSFER CASE PROPELLER SHAFT MAINTENANCE (Cod)
b. Disassembly
1.
Remove grease fitting (5) from input yoke (4).
2.
Remove four screws (1), lockwashers (2), and cross assembly (3) from input yoke (4). Discard
lockwashers (2).
3.
Separate input yoke (4) from output yoke (7). Replace oil seal (6) if damaged.
c. Assembly
NOTE
Perform step 1 only if seal was removed.
1.
Install
seal assembly (6) over splined output yoke (7).
2.
Install
output yoke (7) into input yoke (4).
3.
Install
cross assembly (3) on input yoke (4) with four new lockwashers (2) and screws (1).
4.
Install
grease fitting (5) on input yoke (4).
d. Installation
1.
Install propeller shaft (13) between transmission yoke (9) and transfer case yoke (12) with four new
lockwashers (10) and screws (11). Tighten screws (11) 90-110 lb-ft (122-149 N.m).
2.
Place transfer case lever (8) in neutral position.
3.
Turn propeller shaft (13) until remaining screws (11) can be installed.
4.
Place transfer case lever (8) in high position.
5.
Install propeller shaft (13) between transmission yoke (9) and transfer case yoke (12) with four
remaining new lockwashers (10) and screws (11). Tighten screws (11) 90-110 lb-ft (122-149 N.m).
3-408
