TM 9-2320-272-24-1
3-119. FLOODLIGHT SEALED BEAM LAMP AND DOOR (M936/A1/A2) REPLACEMENT
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP:
APPLICABLE MODELS
EQUIPMENT CONDITION
M936/A1/A2
l Parking brake set (TM 9-2320-272-10).
l Battery ground cables disconnected (para. 3-126).
TOOLS
GENERAL SAFETY INSTRUCTIONS
General mechanic's tool kit (Appendix E, Item 1)
Lamp door retaining clips are under tension.
REFERENCES (TM)
TM 9-2320-272-10
TM 9-2320-272-24P
NOTE
All floodlight sealed beam lamps and doors are replaced the
same way.
a. Removal
1.
Remove three screws (1) and retaining rings (2) from lamp door (10).
2.
Separate lamp door (10) from lamp housing (6).
3.
Remove two screws (5) and wires (8) from sealed beam lamp (4).
WARNING
Lamp door retaining clips are under tension and must be removed
with firm grip or injury to personnel may result.
NOTE
Note position of clips for installation.
4.
Remove four retaining clips (3) from lamp door (10).
5.
Remove sealed beam lamp (4) from lamp door (10).
b. Installation
1.
Install sealed beam lamp (4) on lamp door (10). Align lamp (4) with notch (11) on lamp door (10).
2.
Install four retaining clips (3) on lamp door (10).
3.
Install two wires (8) on lamp (4) with two screws (5).
4.
Align drain hole (9) in door (10) with notch (7) in lamp housing (6) and install lamp door (10) on
lamp housing (6) with three screws (1) and retaining rings (2).
3-322
