TM 9-2320-272-24-1
NOTE
Male pipe threads must be wrapped with antiseize tape before
installation.
1.
Install new gasket (29) and aftercooler (6) on engine block (26) with thirteen screws (14). Tighten
screws (14) 28 lb-ft (24 Nm).
2.
Install two new seals (22) and elbows (21) and (23) on engine block (26).
3.
Install two hoses (17) and water supply tube (27) on aftercooler (6) and elbow (21) with four hose
clamps (19).
4.
Install two hoses (18) and water return tube (20) on aftercooler (6) and elbow (23) with four hose
clamps (16).
5.
Install clamping plate (25) on engine block (26) with screw (24).
6.
Install crossover tube (15) on aftercooler (6) and turbocharger (28) with two clamps (16).
7.
Install two clamps (11) on aftercooler (6) with two screws (9).
8.
Install clamp (10) and throttle control solenoid bracket (2) on aftercooler (6) with two screws (3).
9.
Connect plug (1) to wiring harness plug (13).
10.
Rotate two clamps (8) into position on aftercooler (6) and install with screws (7) and (4).
11.
Install tube brace (12) on aftercooler (6) with screw (5).
3-218
