TM 9-2320-272-24-1
4.
Loosen jamnut (2) on adjusting screw (3).
5.
Push fan pulley bracket (6) toward accessory drive pulley (12) and remove two fan drivebelts (5).
Inspect two fan drivebelts (6) for cracks, splits, and breaks. Replace both belts (5) if either one fails
inspection.
Fan drivebelts must be replaced in matched sets. Failure to do so
will result in premature belt wear or failure.
1.
Position two fan drivebelts (5) over fan clutch pulley (11) and in first and second grooves of
accessory drive pulley (12).
2.
Complete installation with correct tensioning of drivebelts (5). Refer to task a.
FOLLOW-ON TASKS:
Start engine (TM 9-2320-272-10) and idle for five minutes.
Install right splash shield (TM 9-2320-272-10).
3-205
