TM 9-2320-272-24-1
WARNING
Do not perform this task when engine is hot. Doing so may result
in injury to personnel.
NOTE
Have adequate drainage container ready to catch oil.
Perform step 1 for M939/A1 series vehicles and step 2 for
M939A2 series vehicles.
1.
Remove oil sampling valve (2) from engine oil cooler (1).
2.
Remove oil sampling valve (2) from engine block (3).
1.
Apply a thin coat of gasket sealant to male threads of oil sampling valve (2).
NOTE
Perform step 2 for M939/A1 series vehicles and step 3 for M939A2
series vehicles.
2.
Install oil sampling valve (2) on engine oil cooler (1).
3.
Install oil sampling valve (2) on engine block (3).
FOLLOW-ON TASKS: Start engine (TM 9-2320-272-10) and check for leaks.
Check oil level and add oil as necessary (TM 9-2320-272-10).
Install right splash shield (TM 9-2320-272-10).
3-40
