TM 9-2320-260-34-2
16-25. HOIST BEVEL GEARCASE REPAIR (M816) (Contd)
7.
Remove screw (23), lockwasher (22), and washer (21) from driveshaft (14). Discard lockwashers (22).
NOTE
Tag gear and shaft for installation.
Using puller, remove bevel gear (20) and woodruff key (19) from driveshaft (14). Discard woodruff
8.
key (19).
9.
Remove snapring (24) from housing (13).
10.
Using arbor press, press driveshaft (14) toward gearcase end of housing (13) until bearing (18) clears
housing (13).
11.
Using puller, remove bearing (18) from driveshaft (14).
12.
Using arbor press, turn housing (13) over, and press driveshaft (14) and bearing (17) out of pump
end of housing (13).
13.
Using arbor press or mechanical puller, remove bearing (17) from drive shaft (14).
14.
Remove screw (25), lockwasher (26), washer (27), yoke (28), and spacer (29) from input shaft (30).
Discard lockwasher (26).
16-147
