TM 9-2320-260-34-2
15-77. FLEXIBLE CONVERTER WIRING HARNESS REPLACEMENT
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP
REFERENCES (TM]
APPLICABLE MODELS
TM 9-2320-260-10
M820, M820A2
TM 9-2320-260-20
TEST EQUIPMENT
TM 9-2320-260-34P-2
Multimeter (Appendix B, Item 115)
EQUIPMENT CONDITION
External power source disconnected
TOOLS
(TM 9-2320-260-10).
General mechanic's tool kit
Battery ground cable disconnected
(Appendix B, Item 1)
(TM 9-2320-260-20).
Tool kit, electrical (Appendix B, Item 106)
CAUTION
Use care when replacing wiring harness. Excessive snagging or
pulling may damage wiring harness.
a. Removal
NOTE
The flexible converter wiring harness and 400 Hz output wiring
harness are replaced the same. This procedure covers the flex-
ible converter wiring harness.
Tag wires, cables, and leads for installation.
1. Disconnect connector (10) from junction box (9).
2. Remove four screws (1), cover (2), and gasket (3) from converter (6).
3. Remove three nuts (11), wires (7), and lockwasher (5) from converter (6).
4. Remove flexible converter wiring harness (8) from van body (4).
b. Installation
1. Position flexible converter wiring harness (8) in converter (6) and install lockwasher (5) over flexible
converter wiring harness (8).
2. Install three wires (7) in converter (6) with three nuts (11).
3. Install gasket (3) and cover (2) on converter (6) with four screws (1).
4. Connect connector (10) to junction box (9).
15-282
