TM 9-2320-260-34-2
15-67. ELECTRIC HEATER (10 kW) WIRING HARNESS REPLACEMENT (Contd)
b. Installation
1.
Position electric heater wiring harness (5) in van body (8). Ensure electric heater wiring harness (5)
is routed through grommet (3), twelve clamps (6), and clamp (13).
Install clamp (13) on mounting plate (14) with screw (12).
2.
Install three wires (19) in 30-amp circuit breaker (17) with three screws (18).
3.
Install wire (20) in neutral bar (16) with setscrew (21).
4.
Install cover (11) on load center (15) with six screws (10).
5.
6.
Connect three wires (23) to three wires (25) with three new insulated wire splices (24).
7.
Install thermostat (26) on control center box (22) with two screws (27).
Install cover (28) on thermostat (26).
8.
9.
Connect wires (1) and (2) to electric heater (9).
10.
Install grommet (3) in van ceiling (4).
Secure electric heater wiring harness (5) to van ceiling (4) with twelve clamps (6) and screws (7).
11.
15-254
