REAR FENDERS REPLACEMENT

TM 9-2320-260-34-2

15-9. REAR FENDERS REPLACEMENT

THIS TASK COVERS:

a. Removal

b. Installation

INITIAL SETUP

APPLICABLE MODELS

REFERENCES (TM]

M819

TM 9-2320-260-10

TM 9-2320-260-34P-2

TOOLS

EQUIPMENT CONDITION

General mechanic's tool kit

Parking brake set (TM 9-2320-260-10).

MATERIALS/PARTS

Eighteen lockwashers (Appendix D, Item 222)

Two lockwashers (Appendix D, Item 247)

NOTE

Both rear fenders are removed and installed the same. This proce-

dure covers one rear fender.

1. Remove two screws (6), nuts (3), and lockwashers (4) from rear fender (5), two clamps (1), and

flange (2). Discard lockwashers (4).

2. Remove six nuts (17), lockwashers (18), and screws (7) from rear fender (5) and two braces (11).

Discard lockwashers (18).

3. Remove eight nuts (9), lockwashers (8), four screws (16), and screws ( 10) from rear fender (5) and

tractor wrecker body (12). Discard lockwashers (8).

4. Remove four screws (19), nuts (15), and lockwashers (14) from rear fender (5) and splash guard (13).

Discard lockwashers (14).

NOTE

Assistant will help with step 5.

5. Remove fender (5) from tractor wrecker body ( 12).

NOTE

Assistant will help with step 1.

1. Position rear fender (5) on tractor wrecker body ( 12).

2. Install four screws (19), new lockwashers (14), and nuts (15) on rear fender (5) and splash

guard (13).

3. Install four screws (10), screws (16), eight new lockwashers (8), and nuts (9) in rear fender (5) and

tractor wrecker body (12).

4. Install six screws (7), new lockwashers (18), and nuts (17) in rear fender (5) and two braces (11).

5. Install two clamps (1) and rear fender (5) on flange (2) with two screws (6), new lock-

washers (4), and nuts (3).

15-18