TM 9-2320-260-34-1
10-8. DIFFERENTIAL AND DIFFERENTIAL CARRIER REPAIR (Contd)
70.
Coat both top of new gasket (4) and gasket surface (11) with light coat of sealing compound and
position on differential carrier housing (5).
71.
Install access cover (3) on gasket (4) and differential carrier housing (5) with ten washers (2) and
screws (1). Tighten screws (1) 27-40 lb-ft (37-54 Nm).
72.
Coat gasket surface (6) with light coat of sealing compound.
Install new gasket (7) and side cover (8) to differential carrier housing (5) with eight washers (10)
73.
and screws (9). Tighten screws (9) 27-40 lb-ft (37-54 Nm).
Lubricate sealing surface of new seal (13) with GM grease, coat metal contact outer diameter with
74.
sealing compound. Install new gasket (14) and seal (13) in front bearing cover (15) with seal installer
tool and arbor press.
NOTE
Ensure oil slots on retainer are not blocked with sealing compound
or covered by new gasket.
Coat both sides of new gasket (12) with light coat of sealing compound and position on retainer (18).
75.
76.
Remove eight screws (16) and washers (17) from retainer (18).
Install front bearing cover (15) and new seal (13), gasket (12), and retainer (18) on carrier hous-
77.
ing (5) with eight washers (17) and screws (16). Tighten screws (16) 93-120 lb-ft (126-163 Nm).
78.
Lubricate sealing surface of new seal (25) with GAA grease, coat outside metal contact outer
diameter with sealing compound, and install in bearing cover (26) with seal installer tool.
Coat new gasket (24) with light coat of sealing compound and position on differential carrier
79.
housing (5).
Place thrust washer (23) over mainshaft (22) and install rear bearing cover (26) with six new lock-
80.
washers (28) and screws (27). Tighten screws (27) 24-40 lb-ft (33-54 Nm).
CAUTION
Do not tap or hammer companion flanges on driveshaft assembly.
Install two companion flanges (21) on main shaft (22) with two nuts (20). Tighten nuts (20)
81.
300-400 lb-ft (407-542 Nm) and install with new cotter pins (19).
10-46