TM 9-2320-260-34-1
10-4. WHEEL HUB SPINDLE MAINTENANCE (Contd)
6. Using arbor press and bearing replace, install new spindle bearing (6) into spindle (5). Ensure oil
groove of spindle bearing (6) alines with machined grooved of spindle (5).
c. Installation
1.
Install spindle bearing (6) in spindle (5).
Apply a bead of sealing compound around steering knuckle face of spindle (5) just inside stud holes.
2.
3.
Lubricate spindle bearing (6) and bushing journal of axle (14) with GAA grease.
Carefully slide spindle (5) over axle (14) and position over studs (13).
4.
Install plate assembly (3) and deflector (15) on steering knuckle (12) with ten new lockwashers (16)
5.
and nuts (17). Tighten nuts (17) 130-167 lb-ft (176-226 Nm).
Install spring (1) on brakeshoes (2).
6.
Install brake line (11) and hydraulic fitting (8) on wheel cylinder (4) with new gaskets (7) and (9)
7.
--
and screw (10).
Install hub and drum assembly (TM 9-2320-260-20).
FOLLOW-ON TASKS:
Bleed brakes (TM 9-2320-260-20).
Lubricate differential (LO 9-2320-260-12).
10-15