TM 11-7440-293-14
4-47. INSTALLING CURBSIDE AND ROADSIDE ANTENNA MASTS.
This task covers:
Installation
INITIAL SETUP
Personnel Required
Tools
One mechanic
1/16-inch hex wrench
1-inch open end wrench
Equipment Condition
Wire cutters
Antenna mount assembly
Materials/Parts
installed.
Antenna mast (3 required)
Lock wire
Electrical tape
ACTION
REMARKS
ITEM
LOCATION
Pull electrical contact up out of antenna
Antenna mounting
1. Front curbside
mounting base as far as it will go. Using
base (1), setscrew
position on top
hex wrench, tighten setscrew until resistance
of fender
(2) and electri-
is felt.
cal contact (3)
Install.
O-ring (4)
2. Antenna mounting
base
4-88
