TM 10-5411-234-13&P
CARGO BED COVER (CBC), TYPE IV, 5 T CARGO TRUCK, MTV, AND MTV TRAILER
0005 00
OPERATION UNDER USUAL CONDITIONS
Install the lower door latch rod (1) in its operational position by sliding it down through the two door latch
rod guides (8) located on the lower door panel (9).
Engage the upper hole (10) on the door latch rod (1) onto the pin (11) of the door latch (6) from which it
was removed in an earlier step. Install the hairpin cotter (4) to secure the door latch rod (1).
Test the action of the door latch (6) by opening and closing the assembled personnel door. Ensure that
the door closes properly, that the door latch rods at the upper and lower edges of the door engage
properly in their contact points, and that the center case latch engages the strike plate properly.
Make sure that the door operates freely and that the weather seal surrounding the door is positioned
properly to block all openings. If the personnel door does not operate smoothly, check to make sure that
the lower panel of the personnel door has been installed correctly and that the tabs and cutouts on the
inside surface of the personnel door are aligned correctly. Ensure that the three hand knobs with
threaded studs are securely tightened.
Once the personnel door has been properly installed, the fully extended Cargo Bed Cover is ready for
use.
4
6
11
9
8
1
10
0005 00-12
