KEY
REFILL
EXPECTED TEMPERATURES*
LUBRICANTS/COMPONENTS
CAPACITY
INTERVALS
(APPROX)
+5F to +120F
+40F to -60F
40 qt. or
OE/HDO (MIL-L-2104D)
LUBRICATING OIL
OE/HDO-15/40
OEA
AF - After
10 gal.
OR OEA (MIL-L-46167)
INTERNAL COMBUSTION
S - Semi-annual
ENGINE
AN - Annually or
Transmission
(MIL-L-21260)
PE 30-1
Every 1,500
Miles
(See Note 11)
PRESERVATION OIL
OC - On Condition
For Arctic Operation Refer to FM 9-207
NOTES
1. TRANSMISSION OIL FILL. OE/HDO 15/40 MUST
5. HARD TIME INTERVAL. If AOAP Laboratory is
not available, every 1,500 miles or annually, drain oil,
NOT be mixed with single grade lubricants.
change filter. Hard time interval may be shortened if
you are operating the equipment under adverse
2. A complete oil and filter change is required when
conditions.
converting to a different grade of oil in accordance with
Temperature Key Chart.
6. TRANSMISSION OIL FILTER. Replace filter
element and packings each time a transmission oil
CAUTION
change is required. When AOAP Laboratory support
Transmission can be damaged when filled above
is not available, change transmission oil filter annually,
FULL mark.
or every 1,500 miles, or when transmission differential
pressure light comes on (filter clogged).
3. TRANSMISSION OIL LEVEL. After operation,
check transmission oil level. Oil level should be at
7. OIL FILTER REMOVAL AND INSTALLATION
FULL mark on gauge rod. When oil is warm, oil level
INSTRUCTIONS (TM 9-2350-247-20).
should be at or just above ADD mark on gauge rod.
4. FREQUENCY OF AOAP SAMPLE. Every 30
days, obtain a sample of transmission oil. Samples
should be taken as near the prescribed interval as
possible. If sampling at the prescribed interval is not
possible, a 10 percent variance is permissible.
Card 8 of 40
