TM 9-2320-366-20-5
(8) Install suspension compression plate (13) on suspension
compression plate stud (14) with spring pin (15).
(9) Install dust boot (16) on 200 amp terminal block to PDP
12 vdc cable (1).
(10) Position terminal lug TL80 (17) on terminal block terminal
(18) with washer (19), lockwasher (20), and nut (21).
(11) Tighten nut (21) to 15-19 lb-ft (21-25 Nm).
(12) Position dust boot (16) on terminal lug TL80 (17).
(13) Position intake air cleaner boot (22) on intake air cleaner
housing (23) with clamp (24).
(14) Position air compressor intake hose (25) on intake air
cleaner boot (22) with clamp (26).
(15) Tighten clamps (24 and 26) to 36-48 lb-in. (4-5 Nm).
(16) Lower cab (TM 9-2320-366-10-1).
20-303